Ofw20: Created page with "I have done my laser induction and thought that I would sit down to play with inkscape, before realising that I had forgotten everything that I was taught at my induction. I was ..."

2014-03-28T21:52:49Z

Created page with "I have done my laser induction and thought that I would sit down to play with inkscape, before realising that I had forgotten everything that I was taught at my induction. I was ..."

New page

I have done my laser induction and thought that I would sit down to play with inkscape, before realising that I had forgotten everything that I was taught at my induction. I was going to recommend that someone put a page on the wiki on how to use inkscape with the cutter but then realised that someone already had. So thank you!

However, if some kind person would fancy doing a quick tutorial on how to make a 41mm spacer (as in the induction) in a form that the laser would understand then that I think would enhance this page. Any takers? If not then I will have a go once I've worked out how to do it myself...

Talk:Equipment/Laser Cutter Inkscape - Revision history

Ofw20: Created page with "I have done my laser induction and thought that I would sit down to play with inkscape, before realising that I had forgotten everything that I was taught at my induction. I was ..."