Difference between revisions of "Equipment/WarcoMill/Training"
From Makespace
(→Owners: created table) |
(→Trained Users) |
||
| Line 33: | Line 33: | ||
|- | |- | ||
| Stevan Wing || Intro || Use while supervised | | Stevan Wing || Intro || Use while supervised | ||
| + | |- | ||
| + | | Robert Karpinski || Intro || Use while supervised | ||
|} | |} | ||
Revision as of 23:06, 29 October 2014
Training
THE MILL CAN CAUSE SERIOUS INJURY. ONLY APPROVED OPERATORS ARE PERMITTED TO USE IT.
Training and induction will start with a tour of the tool introducing all its parts. The following points will be covered.
- Keep hands well away from the spinning parts.
- Make sure there is no loose clothing or hair that can be caught in rotating parts.
- Take care to mount the work securely.
- Swarf has sharp edges so clean it away with a brush.
- Some parts of the machine are very heavy. It is also possible to work on very heavy parts. Loosing control of heavy objects can cause serious injury. Plan work carefully. Using lifting aids if necessary. Ask for assistance if not totally confident of your ability to control the part at all times.
Owners
- Roger Smith
Trainers
- Mat Cook
Trained Users
Training is an initial guide to the mill and safety briefing, followed by a number of individual lessons interspersed with practicing what has been learned.
| User | Trained level | Mill access |
|---|---|---|
| Diana Probst | Intro | Use while supervised |
| Stevan Wing | Intro | Use while supervised |
| Robert Karpinski | Intro | Use while supervised |
Trained operators
- 1
