Difference between revisions of "Ultimaker Maintenance"
From Makespace
(Created page with "== Ultimaker Maintenance == '''To be performed by Ultimaker Owners only''' == Weekly: == * Test print to check build plate is level * Check filament feed tube is fully hom...") |
(→Maintenance Log:) |
||
| Line 28: | Line 28: | ||
See log book with Ultimaker for details. | See log book with Ultimaker for details. | ||
| − | Additional maintenance performed: | + | '''Additional maintenance performed:''' |
| − | Replaced PTFE Coupler and nozzle, levelled build plate. Filament had not been feeding properly. PTFE coupler notably burnt (Stephen Harrison 2015-11-25). Print Time: 425H (484M) | + | * Replaced PTFE Coupler and nozzle, levelled build plate. Filament had not been feeding properly. PTFE coupler notably burnt (Stephen Harrison 2015-11-25). Print Time: 425H (484M) |
Revision as of 14:40, 26 November 2015
Ultimaker Maintenance
To be performed by Ultimaker Owners only
Weekly:
- Test print to check build plate is level
- Check filament feed tube is fully home (No visible ring around tube above white push fit fitting)
- Clean build plate
- Clean base of printer (under/around build place)
- Clean desk
- Remove old files from SD Card
- Check print removal tool available and in good condition
As Needed:
- Clean/Unblock Nozzle Atomic Method
- Replace PTFE Coupler PTFE Coupler
- Replace Nozzle Hot End
- PT1000 sensor is fragile and may break with Nozzle replacement. Change PT1000 Sensor
- Check Silica Gel / Humidity level for filament storage boxes.
Maintenance Log:
See log book with Ultimaker for details.
Additional maintenance performed:
- Replaced PTFE Coupler and nozzle, levelled build plate. Filament had not been feeding properly. PTFE coupler notably burnt (Stephen Harrison 2015-11-25). Print Time: 425H (484M)
