Difference between revisions of "Equipment/Electronics Workbenches"
From Makespace
(→Need: Add "Soldering microscope".) |
(→Would Be Nice: Differentiate USB microscope from soldering mike) |
||
| Line 73: | Line 73: | ||
===Would Be Nice=== | ===Would Be Nice=== | ||
| − | * USB microscope with monitor | + | * USB microscope with monitor (not to be confused with a soldering/lab microscope!) |
* Spectrum Analyser | * Spectrum Analyser | ||
* A PC | * A PC | ||
Revision as of 21:37, 9 April 2015
Class Green equipment: Negligible risk. No formal training is required or offered. If you need help just grab the nearest member and ask.
(More about equipment classes)
Class Orange equipment: Only use if you are confident doing so. Training is available if not.
(More about equipment classes)
Workbenches for electronics and precision work.
Contents
Enthusiast Bench
A 1800mm x 900mm ESD cantilever bench from here
Equipment
- Hameg HM-203-5 20MHz analogue oscilloscope
- Black*Star Jupiter 500 0.1Hz-500kHz function generator (sine, square, sawtooth)
- Philips PM6622 80MHz counter
Expert Bench
A 1800mm x 900mm ESD cantilever bench from here
Equipment
- BlackJack BK6000 Rework station (Class: Orange)
- Rigol DS1104Z 100MHZ Digital Oscilloscope
- Info here.
- Philips PM 3217 50MHz analogue Oscilloscope (Class: Green)
- Thurlby Thandar TG212 0.1Hz-2MHz function generator (sine, square, sawtooth) (Class: Orange)
- Thurlby Thandar TF830 1.3GHz high resolution reciprocal measurement
- Soldering irons:
- 2x Tenma AT60D soldering stations (up to 400C) (Class: Orange)
- Bench power supplies (e.g. a mix of 5V, 12V, variable, and multi-rail PSUs) (Class: Orange)
- Farnell AP20-80: up to 20V at up to 80A
- Hameg HM7042-3 dual: each channel up to 32V at up to 2A
- Tenma 72-8695 two channels each up to 32V at up to 3A, plus a single fixed 5V/2A channel
- Logic analyser:
- HP 16500A (status unknown: may not be operational but has probes pack)
- Currently assumed dead.
- Components and small tools
- PCB holders or "helping hands"
- Magnifying lamps
- Side cutters
- Multimeters
- Wire
- Selection of basic components (res, caps, v-reg, basic digital logic, basic IC's - 555,358, connectors, cable)
- Inspection microscope (fixed 20x monocular, with 80mm clearance under the lens)
Supplies
Wishlist
Need
- Soldering microscope with inbuilt illumination
- Abrasive pen
- Heatsink tweezers
- Tweezers
- ESD handling equipment, eg. anti-static mats, wrist-strap, earth points, tester
- URLs or PDF manuals for the equipment
Want
- Logic Analyser
- Possibly a Saleae Logic16
- A Reflow Oven
- Probably a EuroCircuits EC-Reflow Mate
Would Be Nice
- USB microscope with monitor (not to be confused with a soldering/lab microscope!)
- Spectrum Analyser
- A PC
