Difference between revisions of "Talk:Equipment/Electronics Workbenches/T-962A Reflow Oven"
From Makespace
(Created page with "Okay ish setting s for 125micron mylar: 400mm/s 42% rotate stencil 45° - cutting at 0° or 90° blows out the webs between pads. ToDo seperate page for stencils/SM...") |
|||
| Line 1: | Line 1: | ||
Okay ish setting s for 125micron mylar: | Okay ish setting s for 125micron mylar: | ||
| + | |||
400mm/s | 400mm/s | ||
| + | |||
42% | 42% | ||
| + | |||
rotate stencil 45° - cutting at 0° or 90° blows out the webs between pads. | rotate stencil 45° - cutting at 0° or 90° blows out the webs between pads. | ||
| + | |||
| + | Try reducing the cut, still some webs blew through. | ||
| + | |||
Revision as of 22:58, 4 August 2015
Okay ish setting s for 125micron mylar:
400mm/s
42%
rotate stencil 45° - cutting at 0° or 90° blows out the webs between pads.
Try reducing the cut, still some webs blew through.
ToDo seperate page for stencils/SMD HowTo
