Equipment/Electronics Workbenches

From Makespace
Revision as of 13:36, 23 October 2014 by Pinski1 (Talk | contribs)

Jump to: navigation, search

Equipment / Electronics Workbenches

Workbenches for electronics and precision work.

Electronics-thumb.jpg


Enthusiast Bench

A 1800mm x 900mm ESD cantilever bench from here

Equipment

Expert Bench

A 1800mm x 900mm ESD cantilever bench from here

Equipment

Shared equipment

  • Soldering irons:
    • 2x Tenma AT60D soldering stations (up to 400C)
  • Bench power supplies (e.g. a mix of 5V, 12V, variable, and multi-rail PSUs)
    • Farnell AP20-80: up to 20V at up to 80A
    • Hameg HM7042-3 dual: each channel up to 32V at up to 2A
    • Tenma 72-8695 two channels each up to 32V at up to 3A, plus a single fixed 5V/2A channel
  • Logic analyser:
    • HP 16500A (status unknown: may not be operational but has probes pack)
    • Currently assumed dead.
  • Components and small tools
    • PCB holders or "helping hands"
    • Magnifying lamps
    • Side cutters
    • Multimeters
    • Wire
    • Selection of basic components (res, caps, v-reg, basic digital logic, basic IC's - 555,358, connectors, cable)
    • Inspection microscope (fixed 20x monocular, with 80mm clearance under the lens)

Notes

It would be nice if someone could dig out URLs for manuals for the above, if available, and link to them from their listing lines.

Wishlist

Need

  • Abrasive pen
  • Heatsink tweezers
  • Tweezers
  • ESD handling equipment, eg. anti-static mats, wrist-strap, earth points, tester

Want

  • Logic Analyser
  • 100MHZ Digital Oscilloscope
    • Possibly a Rigol DS1104Z, a 4 channel 100MHz scope
    • DONE!
  • A Reflow Oven

Would Be Nice

  • USB microscope with monitor
  • Spectrum Analyser
  • A PC