Ultimaker Maintenance

Ultimaker Maintenance

To be performed by Ultimaker Owners only

Weekly:

• Test print to check build plate is level
• Check filament feed tube is fully home (No visible ring around tube above white push fit fitting)
• Clean build plate
• Clean base of printer (under/around build place)
• Clean desk
• Remove old files from SD Card
• Check print removal tool available and in good condition

As Needed:

• Clean/Unblock Nozzle Atomic Method
• Replace PTFE Coupler PTFE Coupler
• Replace Nozzle Hot End
• PT1000 sensor is fragile and may break with Nozzle replacement. Change PT1000 Sensor
• Check Silica Gel / Humidity level for filament storage boxes.

Maintenance Log:

See log book with Ultimaker for details.

Additional maintenance performed:

Replaced PTFE Coupler and nozzle, levelled build plate. Filament had not been feeding properly. PTFE coupler notably burnt (Stephen Harrison 2015-11-25). Print Time: 425H (484M)