Equipment/WarcoMill

From Makespace
Revision as of 17:34, 29 November 2013 by RobCopcutt (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

Class Red equipment: Do not use without specific training.
(More about equipment classes)

Equipment / Warco Mill
Warco Mill

Summary

The Warco mill can be used to machine objects from a wide range of materials. Training is required before members use the equipment because it is easy for users to damage themselves and the tool. The machine has a table 660 x 152mm that can move 37 cm in the X direction, 15 cm in the Y and 34 in the Z direction.

Owners

Health and Safety

  • Power supply to be disconnected when changing tools.
  • All cutting tools to be kept in their holders until they are required.
  • Waste material/offcuts to be kept clear of work area.
  • Equipment will be checked for defects before each use to minimise the risk of possible electrical faults or fire.
  • Carbon Dioxide extinguisher to be available for any electrical fires
  • Eye protection to be worn when using the equipment.

Training

Training and induction will start with a tour of the tool introducing all its parts. The following points will be covered.

  • Keep hands well away from the spinning tools.
  • Make sure there is no loose clothing or hair that can be caught in rotating parts.
  • Take care to mount the work securely.
  • Swarf has sharp edges so clean it away with a brush.

Instructions

Tips & Tricks

Maintenance

  • Clean away all swarf at the end of a work session.

Further Information