Equipment/WarcoMill
Class Red equipment: Do not use without specific training.
(More about equipment classes)
Contents
Summary
The Warco mill can be used to machine objects from a wide range of materials. Training is required before members use the equipment because it is easy for users to damage themselves and the tool. The machine has a table 660 x 152mm that can move 37 cm in the X direction, 15 cm in the Y and 34 in the Z direction.
Owners
- Roger Smith
- Robert Copcutt
Health and Safety
- Power supply to be disconnected when changing tools.
- All cutting tools to be kept in their holders until they are required.
- Waste material/offcuts to be kept clear of work area.
- Equipment will be checked for defects before each use to minimise the risk of possible electrical faults or fire.
- Carbon Dioxide extinguisher to be available for any electrical fires
- Eye protection to be worn when using the equipment.
Training
Training and induction will start with a tour of the tool introducing all its parts. The following points will be covered.
- Keep hands well away from the spinning tools.
- Make sure there is no loose clothing or hair that can be caught in rotating parts.
- Take care to mount the work securely.
- Swarf has sharp edges so clean it away with a brush.
Instructions
Tips & Tricks
A climbing cut can put extra strain on the cutting tool. It produces a better finish so climbing cuts are good for light finishing cuts that leave a smooth finish. Use a conventional milling cut to get the part to approximately the final size.
Maintenance
- Clean away all swarf at the end of a work session.