Difference between revisions of "Badge Maker"

From Makespace
Jump to: navigation, search
Line 1: Line 1:
 +
{{GreenTool}}
  
 
[[Equipment]] / Badge Maker
 
[[Equipment]] / Badge Maker

Revision as of 19:04, 10 May 2019

Class Green equipment: Negligible risk. No formal training is required or offered. If you need help just grab the nearest member and ask.
(More about equipment classes)

Equipment / Badge Maker
Bm.jpg

Summary

The badge maker makes 58mm badges. It lives in a box in the craft room.

Using the Badge Maker

Owners

  • Andrew Burrows

Training

See owners for occasional demos.

Safety

  • Pins are sharp, be careful when fitting them into the badge blanks or pinning the badges to clothing.
  • Do not allow body parts to get tangled in the badge maker during use.

Supplies

Bags of supplies are available, each bag contains enough parts to make 10 badges. You can pay for your supplies on iZettle (coming soon).

Instructions

The badge maker is not hard to use but there are a few things you need to get right to get good results. Make sure you read the instructions below (or the ones in the badge maker box) before attempting to use the equipment.

Video Instructions

This video on youtube shows the operation of the badge maker.

Getting Started

You will need:

  1. Badge maker
  2. Handle
  3. Grey Ring C
  4. Centre Punch
  5. Metal ring
  6. Cutter
  7. Cutting mat
  8. Badge Front
  9. Clear Plastic Disc
  10. Pin
  11. Badge Back
  12. Artwork (see useful files section below for template)

Bm1.PNG

Assemble the press

Bm2.PNG

Remove clip

Bm3.PNG

Insert handle

Insert clip

Cut out the artwork

Bm4.jpg

Use a cutting mat to protect desk

Align cutter over artwork

Turn Handle

Bm5.jpg

Step 1

Bm6.jpg

Put metal badge front into die A

Bm7.jpg

Put artwork on top of metal badge front

Bm8.jpg

Put clear plastic disc on top of artwork

Bm9.jpg

Put grey ring C on top of plastic disc

Bm10.jpg

Put centre punch on top

Make sure “step 1 up” stickers are facing up

Bm11.jpg

Align the whole stack under the handle

Bm12.PNG

Push down on handle

Step 2

Bm13.jpg

Place metal ring in the bottom of die B

Bm14.jpg

Install pin into badge back

Put badge back into die B

Ensure “Z” of pin is facing up

Bm15.jpg

Move ring C complete with badge front and artwork to die B

You may wish to consider the pin in relation to the artwork

Bm16.jpg

Put centre punch on top

Make sure “step 2 up” stickers are facing up

Bm17.jpg

Align the whole stack under the handle

Bm18.PNG

Push down on handle

Done

Bm19.jpg

Remove the finished badge and wear with pride!

Top Tips

  • Make sure you install the pin the correct way around in the badge back.
  • Don't forget to install the metal ring in die B.

Useful Files