A sander is a tool designed to sand down or smooth primarily wood for shaping and to prepare it for finishing. It can also be used to smooth or round edges. The sander is rather large and if not used properly can result in damaging to your material or causing serious injury. However, using the sander is a pretty simple operation.
Health and Safety
- Power supply to be disconnected when changing belts or discs.
- Wait for all surfaces to stop moving before adjusting the tool.
Slips, Trips and Falls
- Waste material/offcuts to be kept clear of work area.
- Equipment will be checked for defects before each use to minimise the risk of possible electrical faults or fire.
- Carbon Dioxide extinguisher to be available for any electrical fires
- Do not use for sanding metal, as the resulting sparks can cause sawdust to ignite
- The equipment will be checked before each use to ensure that there are no defects in the casing, battery or cutting head.
- P.P.E. to be worn when using the equipment.
- Regular breakes to prevent fingers becoming numb
Repetitive Action/Physical Fatigue
- Regular breaks if work is lasting more than 5 minutes in duration
If you've never used a belt/disc sander then it would be worth watching this video for an introduction to a similar machine.
Please refer to the product manual for detailed instructions on how to use the belt sander. A printed copy is also kept with the sander. File:Disc Belt manual.pdf
Prepare your wood to be sanded by ensuring it is properly secured on the table or workbench.
Put on the necessary safety gear, such as goggles or gloves. Belt sanders can kick up a lot of sawdust, which can easily fly into your eyes. This could lead to instinctively dropping the sander, which could cause injury.
Start the motor of the belt sander while holding it away from the wood you intend to sand. Ensure it is at full speed before bringing it in contact with the wood. Start with a coarse belt, and finish up the sanding with a finer grit.
Bring the rear of the sander down to the wood, ensuring you have a firm grip on the back handle, which is used to control the sander.
Bring the rest of the sander onto the wood as smooth as possible.
Move the sander back and forth in smooth, even motions, using the front handle to guide it across the wood.
Tips & Tricks
Always move the belt sander parallel to the grain of the wood. This will ensure an even and smooth surface.
Always keep the sander moving, as leaving it running in one place on the wood can prevent an uneven surface.
Don't tip the sander on its side, as the edge of the sander can cut into the wood
Don't put any unnecessary extra pressure on the wood. The belt sander is a heavy instrument and typically uses its own weight to apply even pressure.
Every month inspect for damage and general wear and tear and asses state of stock blades and replace as needed.
Every six months the carbon motor brushes should be inspected for wear, and replaced as necessary.