Difference between revisions of "Equipment/Electronics Workbenches"

From Makespace
Jump to: navigation, search
(Want)
(Would Be Nice)
Line 69: Line 69:
 
* USB microscope with monitor
 
* USB microscope with monitor
 
* Spectrum Analyser
 
* Spectrum Analyser
 +
* A PC
  
 
<!--
 
<!--

Revision as of 22:18, 23 February 2014

Equipment / Electronics Workbenches

Workbenches for electronics and precision work.

Electronics-thumb.jpg


Enthusiast Bench

A 1800mm x 900mm ESD cantilever bench from here

Equipment

Expert Bench

A 1800mm x 900mm ESD cantilever bench from here

Equipment

Shared equipment

  • Soldering irons:
    • 2x Tenma AT60D soldering stations (up to 400C)
  • Bench power supplies (e.g. a mix of 5V, 12V, variable, and multi-rail PSUs)
    • Farnell AP20-80: up to 20V at up to 80A
    • Hameg HM7042-3 dual: each channel up to 32V at up to 2A
    • Tenma 72-8695 two channels each up to 32V at up to 3A, plus a single fixed 5V/2A channel
  • Logic analyser:
    • HP 16500A (status unknown: may not be operational but has probes pack)
    • Currently assumed dead.

Components and small tools

  • PCB holders or "helping hands"
  • Magnifying lamps
  • Side cutters
  • Multimeters
  • Wire
  • Selection of basic components (res, caps, v-reg, basic digital logic, basic IC's - 555,358, connectors, cable)

Notes

It would be nice if someone could dig out URLs for manuals for the above, if available, and link to them from their listing lines.

Wishlist

Need

  • Abrasive pen
  • Heatsink tweezers
  • Tweezers
  • ESD handling equipment, eg. anti-static mats, wrist-strap, earth points, tester

Want

  • Logic Analyser
  • 100MHZ Digital Oscilloscope
    • Possibly a Rigol DS1104Z, a 4 channel 100MHz scope
  • A Reflow Oven

Would Be Nice

  • USB microscope with monitor
  • Spectrum Analyser
  • A PC