Difference between revisions of "Equipment/Electronics Workbenches"
From Makespace
(→Want) |
|||
| Line 46: | Line 46: | ||
** Selection of basic components (res, caps, v-reg, basic digital logic, basic IC's - 555,358, connectors, cable) | ** Selection of basic components (res, caps, v-reg, basic digital logic, basic IC's - 555,358, connectors, cable) | ||
** Inspection microscope (fixed 20x monocular, with 80mm clearance under the lens) | ** Inspection microscope (fixed 20x monocular, with 80mm clearance under the lens) | ||
| − | |||
| − | |||
| − | |||
== Wishlist == | == Wishlist == | ||
| Line 57: | Line 54: | ||
* Tweezers | * Tweezers | ||
* ESD handling equipment, eg. anti-static mats, wrist-strap, earth points, tester | * ESD handling equipment, eg. anti-static mats, wrist-strap, earth points, tester | ||
| + | * URLs or PDF manuals for the equipment | ||
| + | |||
===Want=== | ===Want=== | ||
Revision as of 14:40, 23 October 2014
Equipment / Electronics Workbenches
Workbenches for electronics and precision work.
Contents
Enthusiast Bench
A 1800mm x 900mm ESD cantilever bench from here
Equipment
- Hameg HM-203-5 20MHz analogue oscilloscope
- Black*Star Jupiter 500 0.1Hz-500kHz function generator (sine, square, sawtooth)
- Philips PM6622 80MHz counter
Expert Bench
A 1800mm x 900mm ESD cantilever bench from here
Equipment
- BlackJack BK6000 Rework station
- Philips PM 3217 50MHz analogue Oscilloscope
- Thurlby Thandar TG212 0.1Hz-2MHz function generator (sine, square, sawtooth)
- Thurlby Thandar TF830 1.3GHz high resolution reciprocal measurement
- Soldering irons:
- 2x Tenma AT60D soldering stations (up to 400C)
- Bench power supplies (e.g. a mix of 5V, 12V, variable, and multi-rail PSUs)
- Farnell AP20-80: up to 20V at up to 80A
- Hameg HM7042-3 dual: each channel up to 32V at up to 2A
- Tenma 72-8695 two channels each up to 32V at up to 3A, plus a single fixed 5V/2A channel
- Logic analyser:
- HP 16500A (status unknown: may not be operational but has probes pack)
- Currently assumed dead.
- Components and small tools
- PCB holders or "helping hands"
- Magnifying lamps
- Side cutters
- Multimeters
- Wire
- Selection of basic components (res, caps, v-reg, basic digital logic, basic IC's - 555,358, connectors, cable)
- Inspection microscope (fixed 20x monocular, with 80mm clearance under the lens)
Wishlist
Need
- Abrasive pen
- Heatsink tweezers
- Tweezers
- ESD handling equipment, eg. anti-static mats, wrist-strap, earth points, tester
- URLs or PDF manuals for the equipment
Want
- Logic Analyser
- Possibly a Saleae Logic16
- 100MHZ Digital Oscilloscope
- Possibly a Rigol DS1104Z, a 4 channel 100MHz scope
- DONE!
- A Reflow Oven
- Probably a EuroCircuits EC-Reflow Mate
Would Be Nice
- USB microscope with monitor
- Spectrum Analyser
- A PC
