Difference between revisions of "Equipment/Laser Cutter/Owner Tips"
DianaProbst (Talk | contribs) (Created page with " {{RedTool}} Equipment / Laser Cutter - Owner hints, tricks, and instructions '''Filter Changing''' Filters come in big (pre-filter) and small (carbon fine fi...") |
DianaProbst (Talk | contribs) m (→To Do: 21 Jan 2017) |
||
| Line 16: | Line 16: | ||
Filters should be changed in a ratio of 1:2 or 1:3 upper to lower. Pre-filters get clogged up easily, and changed more often. Try 1:2. | Filters should be changed in a ratio of 1:2 or 1:3 upper to lower. Pre-filters get clogged up easily, and changed more often. Try 1:2. | ||
| − | =To Do: | + | =To Do: 20 Jan 2017= |
Change upper filter on Jaws. Mark today's date for upper and a date of early December for lower. | Change upper filter on Jaws. Mark today's date for upper and a date of early December for lower. | ||
Revision as of 02:46, 20 January 2017
Class Red equipment: Do not use without specific training.
(More about equipment classes)
Filter Changing
Filters come in big (pre-filter) and small (carbon fine filter) sizes, and can be changed individually. Filters are kept in the office.
To change, remove both filters and close cabinet door. Turn on machine.
Press up and down arrows together, until green light by tick starts flashing. Then use up/down arrows to adjust air flow. It should be at the lowest setting that gives 4 green speed dots.
Historically the filters have been marked with the date they were put in. This is now being altered so that there is a paper inside each door with the dates for upper/lower filters. Write the date filters were changed on that paper.
Filters should be changed in a ratio of 1:2 or 1:3 upper to lower. Pre-filters get clogged up easily, and changed more often. Try 1:2.
To Do: 20 Jan 2017
Change upper filter on Jaws. Mark today's date for upper and a date of early December for lower.
