Please be aware that this can only be a "best guess" as equipment may break at any time.
- Red = not working
- Orange = see notes
- Green = fully working
All equipment requires induction training before you can use it, except the Vinyl Cutter and TShirt press for which training is available.
|LaserCutter 1 - Betsy*||6 Nov 2014||Filters replaced. May need optical alignment but it's working fine.|
|LaserCutter 2 - Jaws*||11 Dec 2014||Can be used, awaiting better table and monitor.|
|Bandsaw*||Fine toothed blade only. No thick pieces.|
|Wood lathe*||21 Nov 2014||Working, but usable by owners only, because we have no training course yet.|
|Warco Mill*||Working, but usable by owners only. Training course is being written.|
|Vinyl Cutter++||21 Nov 2014||Fixed by resetting baud rate on SB to 38400 - Paul|
|T-Shirt Heat Press++||5 Nov 2014|
Marked * = Red labelled equipment: you need to be inducted before use of this equipment.
Marked ++ = Orange labelled equipment: use with caution, but you do not need to be trained (you do need to be an inducted keyfob holding Makespace member)