Please be aware that this can only be a "best guess" as equipment may break at any time.
- Red = not working
- Orange = see notes
- Green = fully working
All equipment requires induction training before you can use it, except the Vinyl Cutter and TShirt press for which training is available.
|LaserCutter 1 - Betsy*||19 Feb 2015|
|LaserCutter 2 - Jaws*||10 Mar 2015||Not cutting - probably a cut-out problem. Head occasionally "judders". May cause alignment issues. Owners aware but confused.|
|Makerbot 3D Printer*||23 Feb 2015||Working, except RH extruder|
|"Up" 3D Printer*||07 Jan 2015||Working with new control board (thinks it's a Rep-Rap) but needs documented toolchain|
|Bandsaw*||Fine toothed blade only. No thick pieces.|
|Wood lathe*||21 Nov 2014||Working, but usable by owners only, because we have no training course yet.|
|Warco Mill*||23 Dec 2014||Working, but usable by owners only. Training course is being finalised|
|Vinyl Cutter++||21 Nov 2014||Fixed by resetting baud rate on SB to 38400 - Paul|
|T-Shirt Heat Press++||5 Nov 2014|
Marked * = Red labelled equipment: you need to be inducted before use of this equipment.
Marked ++ = Orange labelled equipment: use with caution, but you do not need to be trained (you do need to be an inducted keyfob holding Makespace member)