Talk:Electrical safety policy

From Makespace
Revision as of 04:45, 20 October 2012 by Cannon Fodder (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

Hi,

I'm Brian,below are my thoughts on electrical safety for Makespace, I have just covered the workshops at the moment. I trained as an electrician and are currently working as a security systems engineer, on Thursday night. I sorted the old 3 phase cables out and removed the old bench sockets cables, got all the sockets working in both workshops.

Electrical Safety

Sockets

The workshop sockets power can be switched off by the Emergency stop buttons around both workshops, the red sockets are not affected, if an emergency stop button is used.

Common practice in high risk areas (in our case the workshops, workrooms) is to use a 30 mA RCD (Residual-current device) to protect users and equipment. This can be done in a number of ways, each has their pros and cons.

1. Single RCD protecting the whole distribution board. Pros - cheap only a single device need for each broad. Cons - There no discrimination between circuits. A fault on a single circuit will trip the RCD, cutting the supply to the whole board.

2. RCBOs(residual-current circuit breaker with overload protection) protecting individual circuits. Pros – discrimination between each circuit, a fault on a single circuit will only affect that circuit. Cons – expensive each circuit needs its own RCBO, all sockets on the circuit is affected when there is a fault.

3. RCD socket/spur protecting single sockets/single bench. Pros - discrimination between each socket/bench, a fault on a single socket/bench will only affect that socket/bench. Cons – expensive

I would use methods 2 or 3 in most cases.

Workshop Machines

Emergency stop buttons to kill power to the workshop machines, some machines may require a power supply for emergency breaking. Each machine will need to be assessed for its power and safety requirements.

I would select methods 2 or 3 in most cases.

Members Projects

Member’s projects should be assessed, case by case.  

PAT (Portable appliance testing) for equipment and power tools

I would suggest that a simple Past or Fail PAT tester is brought and should be very simple to use, that very little training is required in its use. Link to the Health and Safety Executive Q & A on PAT testing

http://www.hse.gov.uk/electricity/faq-portable-appliance-testing.htm

more information, there a table about half way down the page with suggested tests and when they should be done

http://www.hse.gov.uk/electricity/electricequip.htm#suitable