Difference between revisions of "Equipment/PCB Mill/Training"
From Makespace
RobCopcutt (Talk | contribs) (Created page with "= PCB Mill training = Training is done in group sessions. A tour of the mill is given and then the hazards are explained. Each member gets a chance to cut some PCB to learn what...") |
Zoomzoomluke (Talk | contribs) (→Trained user list) |
||
| (One intermediate revision by one user not shown) | |||
| Line 6: | Line 6: | ||
= Trained user list = | = Trained user list = | ||
| − | * | + | * [[user:Zoomzoomluke|Luke Twydell]] (Owner) |
| + | * Adrian van den Heever (Owner) | ||
| + | * Mark Tillotson (Owner) | ||
| + | * Alberto Santos (Owner) | ||
| + | * [[User:Kim_SJ|Kim Spence-Jones]] (Luke Twydell, 24/03/2015) | ||
| + | * Guillaume Tucker (Luke Twydell, 01/04/2015) | ||
| + | * Andrew Gale (Luke Twydell, 01/04/2015) | ||
| + | * William Morton (Luke Twydell, 01/04/2015) | ||
| + | * Andrew Lipson (Luke Twydell, 01/04/2015) | ||
Latest revision as of 00:37, 2 April 2015
PCB Mill training
Training is done in group sessions. A tour of the mill is given and then the hazards are explained. Each member gets a chance to cut some PCB to learn what it feels, sounds and looks like to do it properly. It is expected to take 2 hours.
Damage and danger can be created if the cutting head is made to unexpectedly run into something. Test the work path before mounting a cutting tool.
Trained user list
- Luke Twydell (Owner)
- Adrian van den Heever (Owner)
- Mark Tillotson (Owner)
- Alberto Santos (Owner)
- Kim Spence-Jones (Luke Twydell, 24/03/2015)
- Guillaume Tucker (Luke Twydell, 01/04/2015)
- Andrew Gale (Luke Twydell, 01/04/2015)
- William Morton (Luke Twydell, 01/04/2015)
- Andrew Lipson (Luke Twydell, 01/04/2015)
