Difference between revisions of "Equipment/CNC Router/Hand Controller"
From Makespace
Perfectphase (Talk | contribs) (→Emergency Situation) |
Perfectphase (Talk | contribs) (→Zeroing) |
||
| Line 28: | Line 28: | ||
[[image:Router-OK.png|50px]] + [[Image:Router-8.png|50px]] | [[image:Router-OK.png|50px]] + [[Image:Router-8.png|50px]] | ||
| + | |||
| + | |||
| + | Move to origin | ||
| + | |||
| + | [[image:Router-OK.png|50px]] + [[Image:Router-origin.png|50px]] | ||
== Loading & Starting a Job == | == Loading & Starting a Job == | ||
Revision as of 01:11, 27 June 2013
Equipment / CNC Router / Hand Controller
Contents
CNC Router Hand Controller Guide
The purpose of this page is to act as a guide for those who are not yet fully familiar with all the functions or key commands that operate the CNC Router. The tables below can be used while operating the machine as a quick "look-up" guide.
For more in depth reading, the Router Manual can be found here in PDF form. Router Manual
Lookup Tables
Zeroing
Set the X-Y home: 7
Set the Z home to the current position: 8
Set the Z home to the top of material using sensor: OK + 8
+
Move to origin
+ 
Loading & Starting a Job
Speed Control
Emergency Situation
Pause: Run/Pause
Resume from pause: Run/Pause
